MTurboReverb Ducking

[Frankie.T]

Hi everyone!! New day new question
There is any way in the plugin to duck the reverb?

If not @Melda is it possible to implement it in a future version?


Thank you

[ggio77]

https://www.meldaproduction.com/tutoria ... urboreverb

[Frankie.T]

Thank you for the link, this is made by sidechaining a signal, i was more interested into an ducking knob, like the MTurboDelay ducking knobs

[smadger]

Thank you for the link, this is made by sidechaining a signal, i was more interested into an ducking knob, like the MTurboDelay ducking knobs

Look in the same place, It's all doing the same thing, there are options to use the dry signal. The video is outdated but it's all there in the current versions. Failing that just use a Follower in the Modulators. No need for extra knobs and buttons.

[sparella]

Like smadger said, look in the Globals section of the Dynamics panel and activate "Dry as side-chain". (Deactivate "Pre" if it is enabled.) After that, enable the Compressor and adjust your Threshold to taste.

[Frankie.T]

Got it, thank you both for the infos!!

Edit: i noticed if i edit the compressor in the edit mode, when i go back in the main UI the settings are not changed, is supposed to work like this? I would prefer to find the same settings, is it possible?

[sirmonkey]

Can you make a multi-parameter knob for this?

[sparella]

Got it, thank you both for the infos!!

Edit: i noticed if i edit the compressor in the edit mode, when i go back in the main UI the settings are not changed, is supposed to work like this? I would prefer to find the same settings, is it possible?

I'm not sure what you mean. If you adjust multiparameters while in edit mode, the knobs associated with them on the GUI will update.

[Frankie.T]

If i go on edit mode and i change i.e the compressor treshold and ratio, then i leave the edit, the value i have in the main UI are not what i setup in the edit mode.

If it's still no clear i'll make a little video

[sparella]

If i go on edit mode and i change i.e the compressor treshold and ratio, then i leave the edit, the value i have in the main UI are not what i setup in the edit mode.

If it's still no clear i'll make a little video

I think I understand now. To keep the knobs synchronized while in edit mode, adjust the multiparameters instead.

[Frankie.T]

If i go on edit mode and i change i.e the compressor treshold and ratio, then i leave the edit, the value i have in the main UI are not what i setup in the edit mode.

If it's still no clear i'll make a little video

I think I understand now. To keep the knobs synchronized while in edit mode, adjust the multiparameters instead.

Perfect, thank you