MautodynamicEQ "internal sidechain" question

[yop21]

Hi,

As I understand, I should be able to dynamically eq a frequency based on the level of another one in MautodynamicEQ. I'm trying to achieve this by opening:
band settings (for target frequency) > Advanced (from dynamic section) > Enable (from the Band-pass section) and adjusting lo and hi pass filter to set the triggering (source) frequency.
But this Band-pass seems to be AFTER the band filter itself, which makes it impossible to use another frequency as trigger.
In more simple terms, is there a way to reduce a low frequency based on the level of a high frequency ?

[sirmonkey]

Try watching this video: Go to about 7:00 - 8:30 in the video. Use "Entire Spectrum", then use "Band Pass" under the ADVANCED tab to filter what is triggering the band. But... is that what you're doing to begin with?
* Did you make sure to use "Entire Spectrum"? If you missed that part, it would explain why you're not getting it to work how you want.

[yop21]

Thanks sirmonkey, that was it. I had seen this video years ago and forgot about it.

[sirmonkey]

Really good video series on this EQ. Expert unpacking of what can be done with this EQ. It's what inspired me to upgrade from the free EQ, and propelled me further into the Meldaverse.