As the title says. I have a project where I had used a track modulator.
After closing and reloading the project the target assignments was rendered ineffective. The targets were still listed, but they did nothing...
I repaired it once by setting up the modulator again, but then same happened again and I rather added a chain and inserted the modulator on the chain level. After the switch to chain there have been no problems anymore.
Not sure whether this is on Bitwig side or on the Synth side ... I've used the CLAP Synth Apricot. It was a simple Macro modulator. After the reload neither Track automation nor wiggeling the dial manually helped.
Can anybody confirm that track modulator assignment gets rendered ineffective after project close/reload?
Thanks & best regards
Peter:H
BW 5 Beta 6 - Track-level Modulator rendered ineffective after close/reload of project
-
- KVRAF
- 2482 posts since 22 Sep, 2016
-
- KVRAF
- 1905 posts since 2 Apr, 2015
It's working fine here, I'm not using clap though.
For a test if you add a BW device as well as your clap one to the chain and then setup the modulation to modulate something in both devices, save, load etc. Is the BW one still working?
For a test if you add a BW device as well as your clap one to the chain and then setup the modulation to modulate something in both devices, save, load etc. Is the BW one still working?
