Hey Linn-forum,
I'm doing some tinkering with the linnstrument firmware (most LEDs and scale related) -- and was wondering:
If there any way to backup my presets while developing? i'm not doing anything (currently) with the flash memory mapping etc so -- is there a way to backup just the NVM where my presets / settings are saved so i can restore them after a fresh firmware flash (as i under the entire flash is erased when using the arduino IDE)?
Thanks!
Backing up Presets during active development?
-
rocklobster343 rocklobster343 https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=354549
- KVRer
- Topic Starter
- 21 posts since 25 Mar, 2015 from Denver, Co
-
FranklyFlawless FranklyFlawless https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=586325
- KVRian
- 808 posts since 24 Oct, 2022 from Abbotsford, British Columbia
You can just modify the presets themselves.
https://github.com/rogerlinndesign/linn ... #L671-L708
After you modify them, sketch and upload using Arduino IDE.
https://github.com/rogerlinndesign/linn ... #L671-L708
After you modify them, sketch and upload using Arduino IDE.
-
rocklobster343 rocklobster343 https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=354549
- KVRer
- Topic Starter
- 21 posts since 25 Mar, 2015 from Denver, Co
ahh thanks for the work around @franklyFlawless