This is bugging the hell out of me. I cannot see how it's done.
This preset is an Arp in the sequence section. It features two lines with an active arpeggiator.
The second line however only triggers the DCW modulation after it runs through the full adsr cycle. Not each time the note activates during the arp. It's a legato effect and I cannot for the life of me see how it's done. I have tried copying the envelope paremeters into a fresh preset but it doesn't replicate it. I cannot see anything in the mod matrix that pertains to this, nor can i see any other parameter that allows this. I'm sure it's something simple, but please put me out of your misery and help me understand how this is done.
I cannot link to a clip of the preset so you'll need to have access to the vst. Thanks
CZ V (arturia) Styrofoam ARP preset question
-
- KVRian
- Topic Starter
- 1191 posts since 31 Dec, 2020
Muh bandcamp: https://automatedhero.bandcamp.com/?fro ... _dashboard
-
- KVRian
- Topic Starter
- 1191 posts since 31 Dec, 2020
I don't know. I can't seem to replicate it and I don't understand why the gate would do that. I think it has something to do with the poly voice count, but again I am at an absolute loss as to figure this out.
Muh bandcamp: https://automatedhero.bandcamp.com/?fro ... _dashboard
