Parameter Event Generator

[focusrite]

Im trying to connect a parameter event generator to a module/vst inside a rack slot. Anyone have a workaround?

Use case: Reverb ducking with an audio follwer

[pljones]

Screenshot 2025-01-02 193610.png

Above is Mulab 10.
Add the slot.
Put the plugin in the slot.
Connect the MPs to the plugin inside the slot.
Outside the slot, create the event generator.
Connect the event generator to the slot event input.
Edit the the event generator to select the target (<-- do this last).

[focusrite]

Above is Mulab 10.
Add the slot.
Put the plugin in the slot.
Connect the MPs to the plugin inside the slot.
Outside the slot, create the event generator.
Connect the event generator to the slot event input.
Edit the the event generator to select the target (<-- do this last).

Thanks for helping me get to the bottom of this

[focusrite]

EDIT. It seems thats not the case. You simply cannot add it after the fader arrow. Pre fader arrow is fine. Resolved

[MuTools]

Note that in case inserting a Parameter Event Generator in a rack slot does not work because of how signals stream, thanks to M10's modular racks you now also have the option to dive into the rack modular area and add a Parameter Event Generator there.

[focusrite]

Note that in case inserting a Parameter Event Generator in a rack slot does not work because of how signals stream, thanks to M10's modular racks you now also have the option to dive into the rack modular area and add a Parameter Event Generator there.

I was adding it outside the rack. Post fader the PEV was only seeing the fader controls, pre fader it works fine

[MuTools]

The PEG only sees the parameters of the first module it is connected to. So if you insert it into the last pre-fader slot it will indeed see the fader section (which is a Mixer Strip module) parameters. Have a look inside the rack modular area. That should clarify the routing visually. If you think there is a bug please elaborate.