First time attempting the GUI Designer for an MXXX device, so I made something simple. A one-click autofader with some extras in there, inspired by a new fade out function in Reaper, which also low pass filters the fade out. Got some ideas from it.
Fun fun fun!
However, when I wanted to go back and edit it some more, I just got a black area and the gui doesn't show. I did not save the project for the device/active preset (still not sure how these relate).
- Is that the reason, or is it something else I should have thought of? Do I have to start over, to change stuff in the device?
Thanks in advance!
Custom GUI Designer Question - I made a gui for an MXXX device but...
-
- KVRist
- 324 posts since 17 Apr, 2013 from Gothenburg, Sweden
You do not have the required permissions to view the files attached to this post.
Win 11 | Latest Reaper | MCompleteBundle
-
- KVRAF
- 2692 posts since 9 Jul, 2015 from UK
Hey 
The device is saved separately from the GUI project. You can export the GUI design to the device at any time, but if you want to make changes, you need to open the GUI project, make the changes and export again.
The device is saved separately from the GUI project. You can export the GUI design to the device at any time, but if you want to make changes, you need to open the GUI project, make the changes and export again.
Jason @ Melda Production
-
- KVRist
- Topic Starter
- 324 posts since 17 Apr, 2013 from Gothenburg, Sweden
Ok, for future reference then. Thanks! 
Win 11 | Latest Reaper | MCompleteBundle