To test softsynths I often use a midi clip with some notes in it which I loop with the in/out markers.
While tweaking ConcreteFx Ensembler I noticed Tracktion sends a 'MidiCntlr66=0' message at the out marker; unfortunately an Ensembler parameter is hooked to this Cntrl number,
so at the end of each loop this parameter is set zero.
What does this Cntrl Change do?
Is there a way to turn it off?
tl.
Q about MIDI clip looping & CC
-
- KVRian
- 736 posts since 8 May, 2002 from ... , germany
-
- KVRAF
- 8114 posts since 13 Jan, 2003 from Darkest Kent, UK
i think it's the sustain pedal controller?
there was big debate about what Tracktion should reset as it loops, all notes off, all notes off individually etc. Maybe Jules needs informing so it can be made optional...
.g
there was big debate about what Tracktion should reset as it loops, all notes off, all notes off individually etc. Maybe Jules needs informing so it can be made optional...
.g
-
- KVRAF
- 8114 posts since 13 Jan, 2003 from Darkest Kent, UK
i think it's the sustain pedal controller?
there was big debate about what Tracktion should reset as it loops, all notes off, all notes off individually etc. Maybe Jules needs informing so it can be made optional...
.g
there was big debate about what Tracktion should reset as it loops, all notes off, all notes off individually etc. Maybe Jules needs informing so it can be made optional...
.g