racks as sends, can you use more than one per track?

[Kang]

I use racks as aux sends to send a tracks signal to another track with effects on it to mix in.

The problem is, when I use more than one send on a channel (example: sending overheads to one aux for compression, and another aux for reverb) I get some type of latency problem or some delay that makes it impossible.

Can anyone offer any way to get around this?

I use the technique described in the tutorial, where you connect the inputs and outputs of the rack, then place this on the channel to be sent and the aux, then adjust the settings accordingly for each.

Thanks

[AD80]

Try using Senderella for sends. Its dead easy and fun for the whole family. Plus no latency.

[P.T.]

I second Senderella.
Also Getout from the same developer is good for multi- out synths. The latency problem is a known issue.

You'll have problems using racks to seperate the different outputs of a synth or sampler unless you build the whole contraption (all outputs and all effects for each output) inside the rack.

If you use Get Out you can send each output to it's own seperate track if you want and the timing problems will be very slight, if any at all.