In addition to my trusty ol' Korg M1 as main keyboard, I use a Novation Remote 25 and a UC-16 as midi contollers (the 25 is two-octave with knobs and sliders, the UC is just knobs).
In T1, this setup works properly. In T2, the setup seems to be exactly the same, all devices are "go" and appear on the edit page--the Korg and the UC16 work fine. But the Remote brings up a message when pointed to: "This midi input is currently being used for an external controller, so won't be receiving normal midi message." So it doesn't work at all.
Ideas?
Tom
Question Re: MIDI contoller-T2
-
- KVRian
- 1112 posts since 17 Jul, 2003 from Kauai, HI
-
- KVRAF
- 4644 posts since 28 Nov, 2002 from Chicago
go to the extrenal controller tab in the settings and deselect your controllers.
That page is *only* for the MCU and C4 devices.
Check the manual for the section on using automation - it describes controler mapping with devices such as yours.
That page is *only* for the MCU and C4 devices.
Check the manual for the section on using automation - it describes controler mapping with devices such as yours.
Someone shot the food. Remember: don't shoot food!
-
- KVRAF
- 10815 posts since 26 Nov, 2004 from UK
disable the "use for an external controller" in the propities of your midi input controler
-
- KVRian
- Topic Starter
- 1112 posts since 17 Jul, 2003 from Kauai, HI
That's der one! Thanks kindly!
Anyone here object if I post a new topic titled, "There Are Too Many T2 Threads"?
Tom
Anyone here object if I post a new topic titled, "There Are Too Many T2 Threads"?
Tom
-
- KVRAF
- 4644 posts since 28 Nov, 2002 from Chicago
I'll laugh. Then I'll delete it. 
Someone shot the food. Remember: don't shoot food!