Hi all,
I find that when tried to load any instrument in Sampletank 2 (the full version) it causes my entire system to freeze up with the only way out being a reboot. This applies both when using the plugin on its own track, and also when it's wrapped up in a rack.
Just for curiosity I tried it with the cut down version of Sampletank 1 and the same thing happens.
Anyone else experiencing something similiar either with Sampletank or other plugins ?
Regards,
bug when using sampletank 2 in Traktion 2
-
- The Teach
- 8273 posts since 23 Jul, 2002 from flatness
ST2 LE working fine in T2 here ...
slainte
rob
slainte
rob-
- KVRAF
- 10815 posts since 26 Nov, 2004 from UK
have you enabled "real time priority mode" in the settings page?
if yes disable it!! thats the only way i have got it to happen over here
Subject
if yes disable it!! thats the only way i have got it to happen over here
Subject
-
- KVRAF
- 10367 posts since 2 Sep, 2003 from Surrey, UK
I have got a similar problem with IK's Sonik Synth 2 Free (from CM85) in T1, and other hosts.
So I think it might not be a tracktion-specific problem.
It might be some sort of driver problem, though - if I switch the audio to DirectSound rather than ASIO, then it works OK. Give that a try.
So I think it might not be a tracktion-specific problem.
It might be some sort of driver problem, though - if I switch the audio to DirectSound rather than ASIO, then it works OK. Give that a try.
-
- KVRer
- Topic Starter
- 9 posts since 28 Dec, 2004
thanks darkstar and djsubject...... yes after disabling priority mode it appears to work fine.
ok now that particular problem is out of the way i have found that traktion only records and plays the instrument sitting on the first channel of the plugin, regardless of what i have selected in the 'OUTPUT COMES FROM' menus. i can use the channel selector to change to one of the other instruments loaded in the plugin but any recorded midi data still plays back with the channel 1 instrument.
anyone have any suggestions on what I may be doing wrong here ?
ok now that particular problem is out of the way i have found that traktion only records and plays the instrument sitting on the first channel of the plugin, regardless of what i have selected in the 'OUTPUT COMES FROM' menus. i can use the channel selector to change to one of the other instruments loaded in the plugin but any recorded midi data still plays back with the channel 1 instrument.
anyone have any suggestions on what I may be doing wrong here ?
-
- KVRAF
- 6740 posts since 25 Mar, 2002 from sheffield, england
Is it MIDI channel you're talking about? If so you can find it in the MIDI clip's properties panel:
That often catches people out who expect to find it set per track, but per clip is more flexible IMO..
That often catches people out who expect to find it set per track, but per clip is more flexible IMO..
-
- KVRAF
- 10367 posts since 2 Sep, 2003 from Surrey, UK
I double-checked the RTPM settings.
With it set Off the Synth is fine. Although once I was not able to open the edit, but after saving and re-opening the project it was OK again.
thanks for the tip, subject.
[edited - for typos]
With it set Off the Synth is fine. Although once I was not able to open the edit, but after saving and re-opening the project it was OK again.
thanks for the tip, subject.
[edited - for typos]