Tracktion Software

stash98 · Post by **stash98** » Tue Apr 12, 2005 1:23 am

i made the noob mistake of having the automate record button on when i was EQing bass! so you can imagine what that sounds like..whats the easiest way to get rid of all your automation and start again? i can't figure it out. i'd to find a better way then just double clicking all the white squares till they go away.

haydxn · Post by **haydxn** » Tue Apr 12, 2005 1:26 am

select an automation line and then look at it's properties panel, there are buttons to manipulate the data

stash98 · Post by **stash98** » Tue Apr 12, 2005 1:49 am

so there isnt a way to just remove the lines completely? some are high on the track and some are low..its a pain.

ModuLR · Post by **ModuLR** » Tue Apr 12, 2005 1:55 am

select the automation curve.. then look in the lower properties panel..
select "delete points from curve" button -> "delete all points from curve"

that's it.

haydxn · Post by **haydxn** » Tue Apr 12, 2005 1:55 am

you can delete all automation points from the line, then you can click the A and hide the line from the track

stash98 · Post by **stash98** » Tue Apr 12, 2005 1:56 am

ok..so when you hide the line from the track (after clearing the points) it's not going to affect volume..even if it's high or low?

stash98 · Post by **stash98** » Tue Apr 12, 2005 2:00 am

ok i got it..thanksguys..still getting it al down..this program rocks..i just have to get used to mixing on it.

IIRs · Post by **IIRs** » Tue Apr 12, 2005 9:08 am

stash98 wrote:so there isnt a way to just remove the lines completely? some are high on the track and some are low..its a pain.

If there are no automation nodes, the line just repesents the current value of that parameter.

Tracktion Software

KVR Audio

how do i reset automation?