I can not record from the S/PDIF output of the card to my matering deck. I would much rather burn a master on it. It is a Dennon DM-550R.
I have set the input on the Dennon to digital but to no avail. Then when I check the card out put only the 1/2w is showing any out put. the S/PDIF does not have any output on the meter at all.
Any ideas?
M - Audiophile 192 S/PDIF Problem
-
- KVRAF
- 12977 posts since 29 Sep, 2003 from Ottawa, Canada
Yup, you have to tell the card what the sync source is, and the two have to share the same sample-rate.
You'd think these settings should be in the S/PDIF tab, but have a look at the "Hardware Settings" tab. I have mine set to use "S/PDIF In" as the master clock, but that's not always going to be the case.
Greg
You'd think these settings should be in the S/PDIF tab, but have a look at the "Hardware Settings" tab. I have mine set to use "S/PDIF In" as the master clock, but that's not always going to be the case.
Greg
-
- KVRist
- Topic Starter
- 209 posts since 11 Jul, 2005 from Waxahachie, Texas
I did as you said Lunch Money and I had signal for a moment then it stopped. It will not unlock it says locked just Single and sync is chosen and the buffer is 384. This has got me stumped. I want to make a good master but this is driving me a little up a wall. I don't have much hair left so there is nothing to pull out.
Last edited by MarioC on Mon Feb 13, 2006 4:17 pm, edited 1 time in total.
Just trying to learn about recording, that is if my head is not too hard.
-
- KVRist
- Topic Starter
- 209 posts since 11 Jul, 2005 from Waxahachie, Texas
Lunch Money thanks for the help. I don't know how I could have forgotten to do that.
Just trying to learn about recording, that is if my head is not too hard.