Can anyone tell me how easy it would be to make a Scarbee Rhodes say, only 4 octaves. I tend to play in the midrange for chords and would like to reduce the memory it takes up with the standard library. Having never done this before I don't know if it's even possible but would assume so.
Thanks
Kontakt 2 smaller Scarbee setup question
-
- KVRist
- 387 posts since 24 Aug, 2004
It would be easy. Very easy.c3boy wrote:Can anyone tell me how easy it would be to make a Scarbee Rhodes say, only 4 octaves. I tend to play in the midrange for chords and would like to reduce the memory it takes up with the standard library. Having never done this before I don't know if it's even possible but would assume so.
Thanks
There are other options to reduce size as well.
Batch convert to 16 bit.Use one of the "lite" patches, etc.
-
- KVRist
- Topic Starter
- 413 posts since 5 Dec, 2005
Yes, im already using the 16 bit samples Phil. Apparently I can acheive what I need to in the mapping section of Kontakt 2. I'll have a look at that soon. I've only had Kontakt 2 a short while but actually in DFD active mode it's barely there for clicks and pops. Im basically looking to get Scarbee D6C and Rhodes into 2GB of RAM, which I can either acheive by DFD or by reducing the playing zone of each, since organ is my main axe.
-
- KVRist
- Topic Starter
- 413 posts since 5 Dec, 2005
From NI Forum
It should be a simple move. Load instrument and open the mapping window. Select the zones you wish to delete and delete them using the zone menu.
After this save under another name - ex. MID (for middle)
It should be a simple move. Load instrument and open the mapping window. Select the zones you wish to delete and delete them using the zone menu.
After this save under another name - ex. MID (for middle)