MuTools

The Funk E-technician · Wed Nov 19, 2008 2:07 pm

Hi,

Is it possible to quantize to groove templates with mu.lab?

Can mu.lab extract a groove template out of a midi file?

Thanks

MuTools · Post by **MuTools** » Thu Nov 20, 2008 4:22 am

No, not yet possible to use custom grids. But it's on the whishlist.

By the way: is there an open standard for 'groove templates'?

linkx1 · Post by **linkx1** » Mon Jan 14, 2013 10:53 am

Through what time you plan to add groove templates? In what look it will be realized in Mulab? Add it in the paid Mulab version

It is possible to make the txt-editor of a template for example in a format -
Note - position, length factor, velocity factor?

MuTools · Post by **MuTools** » Tue Jan 15, 2013 10:05 am

I had selected this FR for implmentation in M5 but especially the browser took much more time than expected and so i had to be more selective on other M5 wishes and this one was postponed. That's the bad news. The good news is that i have been looking into this and it should be reasonably easy to implement. I can't yet give a detailed ETA though.

linkx1 · Post by **linkx1** » Tue Jan 15, 2013 10:45 am

Thank you! Will be waiting:)

kingtubby · Post by **kingtubby** » Tue Jan 15, 2013 2:07 pm

mutools wrote:By the way: is there an open standard for 'groove templates'?

Midi, perhaps. For example, could you use a midi file to capture just the timing information from a sliced audio loop and then apply that timing/groove elsewhere?