MeldaProduction

LGK_Dude · Post by **LGK_Dude** » Tue Sep 08, 2015 9:27 am

Is it possible to make a modulator a "one shot event" triggered by a midi note? As a simple example, lets say I'm modulating a filter sweep. I have Modulator 1 set to normal and have turned on midi reset - re(trigger) to "note-on." However if I hold a long enough note the filter sweep starts over again.

Is it possible to make it so the filter sweep is a "one shot event" meaning it will not cycle but instead will go through its shape once and only trigger again when a midi new note is played?

p.s. your modulation videos are AWESOME!! I had no idea about all this power under the hood of your plugins!!! Mind Blown!

jmg8 · Post by **jmg8** » Tue Sep 08, 2015 9:38 am

Well the normal modulator is more like and LFO. Could you use the envelop with a custom shape? This is one shot.

LGK_Dude · Post by **LGK_Dude** » Tue Sep 08, 2015 9:57 am

The shape isn't really the problem, its the fact the "playhead" (white line going through the modulator shape) is constantly going, when I only want it to start when I trigger a note and stop either when I've let go of the note and/or stops once its gone through its cycle once, whichever comes first. Does that make sense? (its hard to explain this stuff with words, haha!)

jmg8 · Post by **jmg8** » Tue Sep 08, 2015 10:03 am

Yes, I understand. That is why I suggested the envelope. Because it is capable (using custom shape) of achieving the same shape as you need, however it is a one shot. So this will do what you want right?

ZentralmassivSound · Post by **ZentralmassivSound** » Tue Sep 08, 2015 10:23 am

Yes, envelope mode does what you want

LGK_Dude · Post by **LGK_Dude** » Tue Sep 08, 2015 7:09 pm

I'm sorry I misunderstood your first reply, but yes the envelope modulator is exactly what I want! Thank you!!

MeldaProduction · Post by **MeldaProduction** » Tue Sep 08, 2015 7:58 pm

And for the record:

MeldaProduction

KVR Audio

Modulator - make it a "one shot" instead of continuous?