Hi everyone,
I know how to load an instrument, switch to the modular view, edit the module network, edit the front panel, and save. How do I open a blank canvas and begin an instrument from scratch?
-d.vyd
mux patch from scratch
-
- KVRAF
- 13865 posts since 24 Jun, 2008 from Europe
-
- KVRist
- Topic Starter
- 219 posts since 3 May, 2016
OK, I see the templates. Thank you! So, to make new synth, the proper workflow is:
1. Start a new MuLab project
2. Add a new track with the empty synth template
3. Open the template from the rack
4. Make the new synth
Got it.
-david
1. Start a new MuLab project
2. Add a new track with the empty synth template
3. Open the template from the rack
4. Make the new synth
Got it.
-david
-
- KVRAF
- 7412 posts since 8 Feb, 2003 from London, UK
Open MuLab using the Factory "New" template (in this example)
Replace the Basic Synth in the rack with Modules->Other->Mux Modular
Then go from there. That gives you a "bare" Mux with event in/out and audio in/out so it can be a synth or effect.
The one thing to add for a Synth is that using the PolySynth is useful, so using "Factory Presets->Instruments->Templates->Empty Synth" rather than "Mux Modular" is a better start point.
Replace the Basic Synth in the rack with Modules->Other->Mux Modular
Then go from there. That gives you a "bare" Mux with event in/out and audio in/out so it can be a synth or effect.
The one thing to add for a Synth is that using the PolySynth is useful, so using "Factory Presets->Instruments->Templates->Empty Synth" rather than "Mux Modular" is a better start point.