Bitwig

ANALOGYES · Post by **ANALOGYES** » Thu Jun 11, 2026 11:31 am

Hi,
So, what I am doing is sending a held chord on my controller to a BWS track which is playing a VST. I then engage the transport to start a VST sequencer playing a separate track VST. The sequencer starts and the held chord is stopped. Any thoughts. Don't know if there is any way around this. BWS V6.0.6.
Thanks,
B-

stamp · Post by **stamp** » Thu Jun 11, 2026 2:09 pm

Do you have note chase turned on? Maybe the two things are connected... just guessing.

ANALOGYES · Post by **ANALOGYES** » Sun Jun 14, 2026 7:42 pm

Hey Stamp,
No, it's not that. Thanks for the response.
B-

pdxindy · Post by **pdxindy** » Sun Jun 14, 2026 11:11 pm

ANALOGYES wrote: Thu Jun 11, 2026 11:31 am Hi,
So, what I am doing is sending a held chord on my controller to a BWS track which is playing a VST. I then engage the transport to start a VST sequencer playing a separate track VST. The sequencer starts and the held chord is stopped. Any thoughts. Don't know if there is any way around this. BWS V6.0.6.
Thanks,
B-

I just tried it here and the held chord is not cut off.

Bitwig

KVR Audio

Trasport start cuts off playing track