Where is the highpass and lowpass in MModernCompressor?

[Babymetalrocks]

I found it on MCompressor but i cant seem to figure where it is on MModernCompressor.

I dont want it to react to bass frequencies.

Thank you!

[vanerio]

I found it on MCompressor but i cant seem to figure where it is on MModernCompressor.

I dont want it to react to bass frequencies.

Thank you!

It is in the DYNAMICS section. There is an EQ button that lets you set a full 6 band eq. So it's not as straightforward as a simple high-pass knob, but it's far more precise (slope & Q) and customizable.

[Babymetalrocks]

[/quote]

It is in the DYNAMICS section. There is an EQ button that lets you set a full 6 band eq. So it's not as straightforward as a simple high-pass knob, but it's far more precise (slope & Q) and customizable.
[/quote]

So I turn on band 1 and drag it all the way to the bottom to the -24 db and make sure it covers 0 hz to 500 hz and that should be good?

[Babymetalrocks]

I found it on MCompressor but i cant seem to figure where it is on MModernCompressor.

I dont want it to react to bass frequencies.

Thank you!

It is in the DYNAMICS section. There is an EQ button that lets you set a full 6 band eq. So it's not as straightforward as a simple high-pass knob, but it's far more precise (slope & Q) and customizable.

So I turn on band 1 and drag it all the way to the bottom to the -24 db and make sure it covers 0 hz to 500 hz and that should be good?

[dakkra]

You can right click the band drag handle to change the filter type to hipass

[Babymetalrocks]

You can right click the band drag handle to change the filter type to hipass

https://ibb.co/xtLgctfM

This is what it looks like with it set to 500 hz. Is that showing its only high passing all sounds below 500?

[jmg8]

You have to right-click on the node (4) to open the settings window, then change it to high-pass. It will look like this...