You mean with a DC Blocker there's still too much below 20 Hz?ffx wrote: Sat Jul 25, 2026 6:16 pm Well, I still think there is too much going on below 20Hz in Zebra3...
Zebra 3.0.2 Update (rev. 22175)
-
- KVRian
- 819 posts since 18 May, 2007 from Berlin
-
- KVRist
- 201 posts since 28 Jun, 2013
Yes, with DC blocker I will get a more balanced signal, if I then add a 20Hz highpass filter after the synth. Maybe I am just mixing up stuff here, and it depends on phase shifts or whatever.
Bored? Check out this chiptune player page (Hint: Press [space] to get a new tune)
-
- KVRer
- 5 posts since 21 Jan, 2011
Hello,
Reaper is crashing (W11) after doing 2 times "cut away curve above guide". Doing only one cut is fine but after the second cut on another curve Reaper is closing. Is that something known?
Reaper is crashing (W11) after doing 2 times "cut away curve above guide". Doing only one cut is fine but after the second cut on another curve Reaper is closing. Is that something known?
-
- KVRer
- 5 posts since 21 Jan, 2011
This is not something systematic.
It occured after having done some modifications with the shapes tools.
Another issue is that "cut away curve above guide" is not always doing the expected result. Sometime I've got part of the curve below the guide cut away.
It occured after having done some modifications with the shapes tools.
Another issue is that "cut away curve above guide" is not always doing the expected result. Sometime I've got part of the curve below the guide cut away.