Zebra 3.0.2 Update (rev. 22175)

[Viktor [TUC]]

Well, I still think there is too much going on below 20Hz in Zebra3...

You mean with a DC Blocker there's still too much below 20 Hz?

[ffx]

Yes, with DC blocker I will get a more balanced signal, if I then add a 20Hz highpass filter after the synth. Maybe I am just mixing up stuff here, and it depends on phase shifts or whatever.

[babacane]

Hello,
Reaper is crashing (W11) after doing 2 times "cut away curve above guide". Doing only one cut is fine but after the second cut on another curve Reaper is closing. Is that something known?

[babacane]

This is not something systematic.
It occured after having done some modifications with the shapes tools.
Another issue is that "cut away curve above guide" is not always doing the expected result. Sometime I've got part of the curve below the guide cut away.

[tasmaniandevil]

Hello,
Reaper is crashing (W11) after doing 2 times "cut away curve above guide". Doing only one cut is fine but after the second cut on another curve Reaper is closing. Is that something known?

Not a known issue and cannot reproduce right now on Windows 11 in Reaper. If you have a way to reproduce this, can you please contact our support?

[tasmaniandevil]

I may have found a regression.
My Linux build of Zebra 3.0.2 (rev 22175) does not draw target finders (no Highlights, Tentacles, or Lasers).

Indeed, looks like it's broken on Linux in the newest update. We’ll fix it for the next update. Thanks for letting us know.

[Alexander_D]

Is this OK, that when I load Zebra, the right zone (Env, LFO) of Zebra loads later than the left zone? Looks strange. Or it's the bug?

[babacane]

Thanks for your reply.
Just sent an email to your contact support with instruction to reproduce my issue. I hope this will be sufficient!
Thanks again!