Have a new receptor 2 and headphone out works fine as does SPDIF out , but there appears to signal from the analog outputs .
I assume one can just plug 1/4 " jacks into these and connect it to a mixing desk or similar but there is no output.
Have post a support ticket but of course it's daylight here while it's night over there.
Can't anything re this as a problem in faq or this forum
Solution needed urgently gig Saturday.
Rick
No analog output Receptor 2
-
- KVRist
- 269 posts since 23 May, 2008 from Lake Stevens, WA, USA
Arjayiii,
When I received my new Receptor 1 about a year and a half ago, I had a problem with no analog output from the main outs as well as no headphone outputs. It turns out that a ribbon cable connector was loose on what I assume was the audio card inside the unit. (There are two connectors on the top of that card; it was the larger of the two that fixed it.) In my Receptor, it's the vertically-standing circuit card next to the hard drive. You might want to press down on all your connections to make sure they're seated properly.
Good luck!
Batgab
When I received my new Receptor 1 about a year and a half ago, I had a problem with no analog output from the main outs as well as no headphone outputs. It turns out that a ribbon cable connector was loose on what I assume was the audio card inside the unit. (There are two connectors on the top of that card; it was the larger of the two that fixed it.) In my Receptor, it's the vertically-standing circuit card next to the hard drive. You might want to press down on all your connections to make sure they're seated properly.
Good luck!
Batgab
-
- KVRer
- Topic Starter
- 9 posts since 5 Feb, 2010 from Inverloch Australia
have had an initial reply from support , if I take the lid off will it void the warranty , the box did travel a long way to get here.
Rick
Rick
-
- KVRist
- 269 posts since 23 May, 2008 from Lake Stevens, WA, USA
Hmmm, odd. When I had my problem I opened up a support ticket, and what they told me to do was just what I told you to do; pop the top and make sure all the connectors are seated. Did they offer you any other troubleshooting hints?
-
- KVRer
- Topic Starter
- 9 posts since 5 Feb, 2010 from Inverloch Australia
not as yet but my support ticket went in only just a few hours ago , and they wouldn't have had a chance to answer but support did answer the ticket with some instructions to make sure the were correctly selected ( which I head already done) and let them know that this hadn;t worked - so I guess I'll get a reply in the morning my time
in the mean time I'll take it out of the rack where I had mounted in anticipation of use
Thanks for your advice
Rick
in the mean time I'll take it out of the rack where I had mounted in anticipation of use
Thanks for your advice
Rick