Question about repr 1 / versus 5 , saw+squareenabled oscilators

[gentleclockdivider]

II never owned one of these in hardware so I can't compare
What I have noticed is when both saw+square ( single osc ) is enabled on pro 5 it sounds like on the sh 101 , while doing the same on the pro 1 , (which gives the effect of the saw being an octave higher ) , because the polarity of the square wave is inverted iow , on the pro 1 the square waveform starts with the positive cycle , whereas on the pro 5 it starts with a negative cycle .
The diffenrence is clearly audible

Is this also the case on the hardware , also wondering why Mr. D.Smith choose this design choice for the pro 1 ?
I much prefer the pro-5 saw square versus pro-1

[gentleclockdivider]

Edit I just noticed there is an saw invert option on repro-5 tweaks page , would be great if the pro -1 had this too

[Urs]

design choice

The main difference is signal gains. IIRC the reason is signals being cut off vs. signals being grounded. Maybe an oversight by the engineer who replaced the Prophet-5's electronic switches with the mechanical switches in the Pro-One.

The saw invert option for Osc B is available in both.

[gentleclockdivider]

Thanks for the clarification , I must have missed the inverted option on the pro 1 .