Maschine MK3 Template for Bitwig 2.2
-
Echoes in the Attic Echoes in the Attic https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=180417
- KVRAF
- 11054 posts since 12 May, 2008
I'm surprised this doesn't exist. Aside from Push it seems like it would be the most useful and common controller out there.
-
- KVRist
- 63 posts since 14 Nov, 2014
The only supported Maschine controller is the Maschine Jam afaik. There was a maschine4bitwig script some years ago, but it's legacy and not supported by Bitwig 2.x or 3.x anymore. It's a pitty because I got a Maschine Micro Mk2 being useless for so long now.
-
- KVRist
- 110 posts since 6 Nov, 2017
I just saw this script for Mikro Mk2 in the NI forum, haven't tried though:smoothny wrote: ↑Sat Nov 09, 2019 9:34 am The only supported Maschine controller is the Maschine Jam afaik. There was a maschine4bitwig script some years ago, but it's legacy and not supported by Bitwig 2.x or 3.x anymore. It's a pitty because I got a Maschine Micro Mk2 being useless for so long now.
https://www.native-instruments.com/foru ... k2.363471/
You could also install DrivenbyMoss where a script for the Mikro Mk3 is included.
Then just change the CCs in Controller Editor accordingly if they are different from your Mikro Mk2 (I did the same with my Maschine Mk1 so that most buttons work with the Mikro Mk3 script).
https://youtu.be/KBIkoGOPBzM
-
- KVRist
- 63 posts since 14 Nov, 2014
May I ask if you would share the MK1 Controller Template with us? Got a friend of mine with an old Maschine MK1.
Greetings,
smoothny
Greetings,
smoothny
-
- KVRist
- 110 posts since 6 Nov, 2017
So it took me a while because my solution was very specific, I tried to make a general version:
viewtopic.php?f=268&t=534634&p=7572958#p7572958
And in theory it also should work with Maschine Mk2 and Mk3!